Operations, Do not – Woo Audio WA7 Fireflies User Manual

Page 12

Advertising
background image

©2013 WOO AUDIO

tm

 Inc. All rights reserved. 

www.wooaudio.com 

Rev 1.2. April, 2013 

12 

 

Operations

NOTE: Only one headphone output is operational at a time. When both headphone
jacks are plugged in, only the ¼” output is operational.

DO NOT

o

Turn on the amp before properly installing ALL tubes and power supply.

o

Block vent holes of the power supply.

o

Use tubes that are not approved by Woo Audio.

o

Align the male plug to the DC input connector. The arrow marking on the plug

should face up when it is properly oriented. Insert the plug into the socket and

turn the locking ring on the plug until fully tightened.

o

Remove any tubes or the umbilical power cord while the amp is operating.

o

Touch tubes (they are extremely hot) after warm-up.

o

Leave the amp running unattended. (We suggest a maximum of 8 hours of

continuous use, allowing the tubes time to cool before using again)

DO

o

Place the amp away from any wireless or frequency-emitting devices such as

mobile phones, PDAs and radios, to avoid noise interference.

o

Keep away from water or excessive moisture.

o

Turn off the amp if its sound is abnormal.

o

Allow a minimum of 2 inches of air clearance for heat dissipation.

o

Allow approximately 3 minutes of warm-up.

o

Allow the tubes to cool down before replacing them.

Advertising