Woo Audio WEE - Manual (Page 9)

©2012 WOO AUDIO
tm
Inc. All rights reserved. www.wooaudio.com Rev 1.0. May 18, 2012. 9
FAQ - Frequently Asked Questions
What headphones are supported?
The WEE is designed to work with 5-pin PRO bias Stax headphones. We can custom
make the unit to accept a 6-pin NORMAL bias headphone.
How do I adjust volume?
It is controlled through your speaker amp that is connected to the WEE.
How good is the WEE compared to a dedicated electrostatic amp?
The WEE is a converter and not an amp. The sound quality depends on your speaker
amp. For the best result, a dedicated amp is recommended.
There is hum/noise coming out of the headphones?
Check your speaker power amp. The WEE does not produce any noise. The noise can
come from the speaker amp only.
The headphones have distortion.
Be advised that you will need a minimum 3 watts of power input to properly power a
Stax headphone.
Is there a maximum power input limit?
There is no upper limit. If you have a high power amp, you should be careful with your
power amp’s volume control.
The LED does not light.
Check if the fuse is burnt. See the following on how to replace a fuse. You will need a 2
or 2A, slo-bloa type.
Insert a small flat
screwdriver into
the fuse door
which located on
the AC inlet. Release the fuse
door by pulling it
out.
The fuse holder is
released from the
AC inlet. The fuse is held by
a clip
.