Zigen HVX-100 - Manual (Page 2)

-2-
Installation
1. Be sure to turn OFF your HD source and HDTV.
2. Connect the HDMI extension cable between HD source
and the “HDMI IN” port of Transmitter.
3. Connect the HDMI extension cable between the HDTV
and the “HDMI OUT” port of Receiver.
4. Connect CAT.5 cables between the Transmitter “LINK”
port and the Receiver “LINK” port of extender.
5. Connect the power cord and power up the extender.
6. Turn on your HD source and HDTV.
IR Receiver Cable Directions:
Plug the IR Receiver into the ZIG-HVX-70-R/
ZIG-HVX-100-R
“IR2 IN” port and place the IR Receiver
Cable, so that you can point to it easily with your IR remote
controller.
IR Emitter Directions:
Plug any brand IR emitter into ZIG-HVX-70-L/
ZIG-HVX-100-L
“IR OUT” port, and place the IR censor
directly on the device ( IR in window located on the front
panel ) which you intend to control.
Additional Options
Select any additional options you may require.
1. IR Receiver Cable
GND
+V
Sig
DO NOT PLUG MONO TIPE IR EMITTER IN TO “IR-IN”
IR-in is design to be used with IR receivers.
-3-
Technical Specifications Output Signal
Pin # Signal Pin # Signal
1 TMDS Data 2+ 11 TMDS Clock Shield
2 TMDS Data 2 Shield 12 TMDS Clock -
3 TMDS Data 2- 13 CEC
4 TMDS Data 1+ 14
Reserved
(N.C. on device)
5 TMDS Data 1 Shield 15 SCL
6 TMDS Data 1- 16 SDA
7 TMDS Data 0+ 17 DDC/CEC Ground
8 TMDS Data 0 Shield 18 +5 Power
9 TMDS Data 0- 19 Hot Plug Detect
10 TMDS Clock+
-4-
Wiring Information & Coding
Conductor
Identification
RJ45 Pin
Assignment
Color Code for
Conductor
Pair 1
5 White-Blue
4 Blue
Pair 2
1 White-Orange
2 Orange
Pair 3
3 White-Green
6 Green
Pair 4
7 White-Brown
8 Brown
-5
© All rights reserved
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or registered
trademarks belonging to their respective companies.