Wilbur Curtis G4GEMSIF - Manual (Page 16)

16
CAP
WASHER
GLASS TUBE
WASHER
SEAT
CUP
Cleaning the Satellite Server
To clean the Satellite components, prepare a mild solution of detergent and warm water..
DO NOT immerse the Satellite in water or any other liquid.
1. Remove lid from Satellite. Clean the lid at the funnel area with a spiral brush and detergent solution.
2. Rinse the lid, removing all traces of cleaning solution.
3. Clean inside of the Satellite. Remove coffee residue with
the detergent solution.
4. Thoroughly rinse out the Satellite with clean warm water.
5. Unscrew the handle/bonnet assembly and remove it
from the dispensing faucet.
6. Inspect the silicone seat cup for wear, cracks, or hard-
ening. If okay, then leave the seat cup attached on the
handle/bonnet assembly. Soak then wipe clean. Replace
the seat cup if damaged.
7. Remove the gauge glass tube by unscrewing the gauge
glass cap.
8. Clean the gauge glass tube with a gauge brush soaked
with detergent solution. Soak and wipe the two washers.
Rinse with clean water. Dry the parts and assemble
them onto the Satellite. Hand tighten the cap.
9. Clean all parts. Thoroughly rinse with clean warm water.
10. Dry and assemble the parts. Hand-tighten when assem-
bling.
Cleaning the Gemini
Regular cleaning and preventive maintenance is essential in keeping your coffee brewer looking and working like new.
To clean the coffee brewer and components, prepare a mild solution of dish washing detergent and warm water.
CAUTION – Do not use cleansers, bleach liquids, powders or any other substance containing chlorine. These
products promote corrosion and will pit the stainless steel. USE OF THESE PRODUCTS WILL VOID THE
WARRANTY.
DAILY CLEANING
1. Wipe exterior surfaces with a damp cloth, removing spills and debris.
2. Slide the brewcone out and clean it. Wipe the sprayhead area with a cloth soaked in a mild detergent solution.
3. Rinse with a cloth soaked with clean water. Dry the brewcone and sprayhead area.
4. Drain drip trays of coffee. Water rinse.
5. Dry the tray.
WEEKLY CLEANING
1. Reach behind the brewer and turn off the power at the toggle switch. Allow the brewer to cool.
2. Clean the sprayhead and dome plate area.
a. Remove the sprayhead, unscrewing counterclockwise from the dome plate.
b. Thoroughly clean and rinse the dome plate area.
c. Clean the brewcone rails with a brush soaked with a mild detergent solution. Rinse the area with a cloth
soaked with clean water, removing any residual detergent.
d. Dry the area.
c. Attach the sprayhead.