Wilbur Curtis GSG-3RED - Manual (Page 2)

2
Adjusting the Grind Texture Adjusting the Grind Texture Adjusting the Grind Texture Adjusting the Grind Texture Adjusting the Grind Texture
1. Empty the hopper of coffee beans.
2. Turn the selector knob clockwise as far as you can, to the ESPRESSO position.
3. Locate the two set screws, under the selector knob. Use an 1/8th inch Allen wench; loosen these screws one turn to free the knob from the adjusting screw.
4. Run the grinder. Turn the adjusting screw slowly clockwise until you hear the grinding burrs making a clicking noise. Back off on the adjusting screw 1/8th turn.
5. Tighten the set screws on the selector knob, your finest adjustment on the selector scale, ESPRESSO, is now set and the rest of the dial positions will be accurate.
Cleaning Cleaning Cleaning Cleaning Cleaning
1. Clean the painted outside case of the grinder with a cloth dampened with dishwashing detergent and water. Dry thoroughly with a soft cloth.
2. Clean the stainless steel front area of the grinder with a stainless steel polish.
3. Clean the inside of the hopper with a dry cloth.
4. Use a stiff brush to remove debris from the housing (see REPLACING A BROKEN SHEAR DISK for opening the grind housing). Keep moisture out of this area.
PARTS DIAGRAM
Item Part No. Description
LABEL, SWITCH PANEL GSG
SWITCH, PUSH BUTTON GREEN 120V N.O.
SWITCH, PUSH BUTTON RED 120V N.O.
DRAWER, GSG
RELAY, 120V, 3 POLE 15A
POWER CORD, 6 FT
CIRCUIT BREAKER 10A 120/220VAC
SWITCH, MICRO GSG
LEVER, BAG SWITCH GSG WC-38036
WC- 149
WC- 150
WC-9177
WC- 435
WC-1200
WC-1504
WC- 151
WC-6487 1
2
3
4
5
6
7
8
9
1
3
2
5
6
4
7
9
8
CONTINUED, PAGE 3
A
A
B