Wilbur Curtis CAR-6 - Manual

ASSEMBLING THE AIRPOT RACK
MODELS: CAR-2, CAR-2T, CAR-3, CAR-4, CAR-6
WILBUR CURTIS COMPANY, INC.
6913 Acco Street, Montebello, CA 90640-5403 • Telephone: 800-421-6150 • 323-837-2300 • Fax: 323-837-2406
10/07 . F-3324 . Rev A
Thank you for selecting this quality Curtis product. A few minutes of assembly is all that is required
to set up this airpot rack for use. The tools you will need are a slotted screwdriver and a small adjust-
able wrench.
The following steps will guide you
through the assembly process.
1.Unpack the box, being careful
not to misplace any of the parts.
2.Install the rubber feet (4 feet on
single row racks 6 feet on step-
up racks). Take the threaded
portion and push it in through
the hole from the bottom of the
rack. From inside the frame,
fasten the rubber feet with the
acorn nuts. Hold the nut with an
adjustable wrench or pair of
pliers while twisting the foot to
tighten.
3. Install the sign holder.
Step-up racks (CAR-2T, CAR-4
& CAR-6 only) have a separate
sign holder for the back row of
airpots. Place it against the back of the rack. Align the holes on the rack with the holes on the
sign holder. Insert the slotted screws, (two provided) to fasten and secure with the acorn nuts.
4. Place the drip trays into the shelves on the racks.
SIGN HOLDER
CAR-2T, CAR-4 & CAR-6
ACORN NUTS
SLOTTED SCREW
RUBBER FOOT