HMDX BLAST™ Bluetooth Boom Box EN - Manual (Page 5)

BLUETOOTH ® CONNECTION: IT’S A SETUP
Like any amazing couple, this one starts with a
connection—one between your device and the
speaker’s Bluetooth.
Here’s how it works:
1. We know you’re probably going to think “derp”
with this one, but we have to say it: Make sure the
smartphone, tablet or computer you want to hook
up to the speaker has Bluetooth. (There. We got that
out of the way.)
2. Turn on the speaker (press and hold for 5 seconds)
and look for the little blinking light.
3. Do whatever your device needs you to do on its end.
(We don’t know what you’re using. We’re not spies.)
4. Look for HMDX Blast in your device’s Bluetooth list
or click YES—whatever pops up on your device—
and BAM! you’re connected.
5. Now hit PLAY on your speaker and crank it up—or
down if you’re lame.
You’re probably only going to have to do this once,
unless your device goes through a major I-just-dropped-
it-in-the-pool kind of reboot. The device and Bluetooth
will find each other every time just as long as the
speaker is set to Bluetooth and your device’s Bluetooth
is, you know—on.
If you’re connecting to a computer, you may have
some extra steps on that end. You’ll have to get that
information from the computer company.
Depending on your device you may be prompted to
enter a pairing code. If prompted enter “0000” as the
code.
Press and hold the PLAY/PAUSE button for 5 seconds
to activate pairing mode.
Note: If you turn on your Blast but haven’t started the
party yet, it will automatically power off after 2 minutes
of inactivity.