HMDX Chill™ Bluetooth® Dual Alarm Clock EN - Manual (Page 3)

4 5
ONE DAY ALARM (HOTEL SETTING)
This alarm clock is equipped with a 1-Day Alarm feature, which allows the alarm to be set
for one day only. To activate this feature:
1. Move the HOTEL switch located on the bottom of the CHILL to the ON position. Once
this switch is in the ON position, the alarm time will need to be reset.
2. Press and hold the desired alarm button (ALARM 1 or ALARM 2) located on the top
of the CHILL. The hour will begin flashing.
3. Use the TUNER (or volume +/-) buttons on top of the CHILL to adjust the hour,
paying attention to the AM and PM indicators.
4. Press the alarm button again and the minute will begin flashing. Use the TUNER
(or volume +/-) buttons again to adjust the minute.
5. Press alarm button again to adjust the maximum volume of the gradual wake feature
(alarm begins soft and slowly gets louder) by using the TUNER (or volume +/-)
buttons to adjust the sound level up or down.
6. Press the alarm button again to select the source. The CHILL’s alarm can be set to
Beep or to FM radio using the TUNER (or volume +/-) buttons. The alarm cannot
be set to the Bluetooth ® source.
Please note: When the 1-Day alarm feature is activated, the alarm will only sound for the
1 day selected.
LISTENING TO A NON-BLUETOOTH ® AUDIO DEVICE
1. Using the 3.5 mm audio cable (not included), plug in the device via the AUX audio line
input located on the rear of the CHILL.
2. Plug the other end of the audio cable into the line out or headphone jack of your
audio device.
3. Press the POWER button located on top of the CHILL.
4. Press the SOURCE button on the unit until the AUX icon appears on the display.
5. Press play on the connected device.
NOTE: You may need to adjust the volume on your audio device to achieve
proper volume.
LISTENING TO THE FM RADIO
(FIG. 1 & 2)
NOTE: For best reception, fully extend the wire antenna. DO NOT strip, alter or attach to
other antennas.
1. To listen to the radio, press the POWER button located on top of the CHILL.
2. Press the SOURCE button on the CHILL until FM and station frequency appears on
the display.
3. Use the TUNER buttons on the top of the unit to select desired station.
4. Press the POWER button to turn unit off.
CHILL BLUETOOTH ® ALARM CLOCK
CONTROLS AND CONNECTIONS
(Fig. 1)
(Fig. 2)
1. Power
2. Alarm 1
3. Tuner
4. Play/Pause
5. Snooze/Dim/Sleep
6. Alarm 2
7. Volume +/-
8. Source
FM
Antenna
Audio Input USB
Output
Time Set
6
4 8
7 3
2
1
DC Input
5
Back of Unit