HMDX Freedom™ Bluetooth Alarm Clock with Lightning Pin EN - Manual (Page 5)

9 10
LISTENING TO YOUR DEVICE WIRELESSLY
OVER BLUETOOTH ®
To connect to Bluetooth ®
1. Press the POWER button located on top of the Unit.
2. Press the Source button on top of unit until “BT” icon image appears on the
LCD screen.
3. Unit will appear as "HMDX FREEDOM" on your device.
4. Follow the instructions of your device to pair the unit.
5. Freedom will sound a hint tone once pairing has occurred and Link will show on
LCD display.
6. Press the PLAY/PAUSE button on the unit to play and again to pause.
7. To skip forward and backward through tracks, press the Previous Track and
Next Track buttons on the unit.
NOTE: A pairing code is not required.
DISPLAY DIMMER CONTROL
(Fig. 2)
Press the Snooze bar to adjust the backlight intensity of clock display. The power
needs to be off to use the dimmer control.
USB CHARGING PORT
• The USB port is for charging only. It cannot be used to play music through the unit.
• In order to use the USB charging feature, you must have the proper cord to connect
to your device with a USB connector on the other end.
To charge your device using the USB charging port (located on the back of the unit):
1. Connect the USB type A end of the device’s cable into the USB port on the rear of
the Freedom.
2. Connect the other end of the USB cable to your device to begin charging.
VOLUME CONTROL
(Fig. 2)
To adjust the volume, press the “ ” and “ ” controls on the top of the unit.
SLEEP FEATURE
While listening to music, press the Snooze button to activate the sleep feature. This
allows you to set a sleep timer for 90, 80, 70...10, or 5 minutes. Once set, the unit will
continue playing for the set length of time, then will automatically turn off.
MAINTENANCE
To Store: You may leave the unit on display, or you can store it in its box in a cool,
dry place.
To Clean: Use only a soft dry cloth to clean the enclosure of the unit.
NEVER use liquids or abrasive cleaner to clean.
FCC DISCLAIMER
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by HDMX could void the user's
authority to operate the equipment.
Por manual de instrucciones e Información de garantía en español visítenos
en www.hmdxaudio.com
9 8