Rane ECM 64 User Manual
Page 4
Manual-4
Typical ECM 64AD Installation
The ECM 64AD is preprogrammed to operate out of the
box using the following system configuration. Run RaneWare,
choose
Device > Restore Memories from File, and load the
ECM 64 file
AP1.C64. In this example we will not use
custom names, just the defaults to keep things clearer.
In this configuration:
•
Mic Mix is routed to the AEC IN
•
Out 1 is used for the AEC REF
•
Line, AUX and HYBRID are routed to Out 1 (to the
loudspeaker amplifier)
•
AEC OUT, AUX and HYBRID are routed to Out 2 (to the
video codec)
•
Mic Mix, Line, AUX and HYBRID are routed to Out 3 (to
the record VCR)
•
AEC OUT, Line and AUX are routed to HYBRID.
The
AP1.C64 file uses two Memories:
• Memory 1 is set for the above application
• Memory 2 allows local speech reinforcement.
In Memory 1, since Out 1 is used for the AEC Reference,
Mics cannot be sent to Out 1 for local speech reinforcement. If
Mics are sent to both the AEC Input and the AEC Reference,
the AEC will not perform properly.
The Memory 2 application solves this problem by chang-
ing the AEC Reference from Out 1 to the mix of Line In and
Aux In. Since Out 1’s Limiter is no longer part of the AEC
Reference, Memory 2 disables Out 1’s Limiter.
See Memory & Security on page Manual-9 for more
information.
Refer to the Appendix for an example of a larger system
combining the ECM 64 with ECS.
Typical ECM 64AD Installation