Rane SEQ 30S and 30L (2003 versions) - Manual

Manual-1
QUICK START
This manual is for both the SEQ 30s and the SEQ 30L. The only difference is the length of the sliders. The units are electrically
and functionally the same. This manual will refer to “SEQ 30” for either unit.
If this is your first equalizer, please do yourself and your speakers a favor and read at least the first five pages. “An ounce of pre-
vention...,” and all that.
The SEQ 30 is a stereo equalizer, so adjusting any slider affects both channels simultaneously. Begin by setting all sliders to their
center detent (0 dB), and the INPUT LEVEL to its center detent (0 dB). Try to make more cuts than boosts. After equalizing, use
the EQ switch to compare equalized and non-equalized signal. While EQ is switched to Active (BYPASS button out), adjust the IN-
PUT LEVEL to the same level as when EQ is switched to BYPASS (in).
You may use either the XLR or ¼" connectors for Inputs or Outputs. Connect only one INPUT type per channel. The XLR and
¼" TRS inputs do not sum. You may, however, use both types of OUTPUTS simultaneously if desired.
WEAR PARTS: This product contains no wear parts.
OPERATORS MANUAL SEQ 30S & 30L
STEREO GRAPHIC EQUALIZERS
12 -12
6 -6
0
STEREO
EQUALIZER
0
+
12
6
9
9
6
3
3
12
0
+
12
6
9
9
6
3
3
12
SEQ 30L
400 31.5 25 40 63 50 100 80 160 125 250 200 315 12.5k 1k 630 500 800 1.6k 1.25k 2k 3.15k 2.5k 5k 4k 8k 6.3k 10k 20k 16k
INPUT
POWER
+4 OL
LEVEL BYPASS
STEREO
EQUALIZER
0
+
12 •
6 •
•
•
6
12
0
+
12 •
6 •
•
•
6
12
12 -12
6 -6
0
SEQ 30S
400 31.5 25 40 63 50 100 80 160 125 250 200 315 12.5k 1k 630 500 800 1.6k 1.25k 2k 3.15k 2.5k 5k 4k 8k 6.3k 10k 20k 16k
INPUT
POWER
+4 OL
LEVEL BYPASS