Rane SP 13 - Manual

Manual-1
OPERATORS MANUAL SP 13
STICK PREAMP
QUICK START
The SP 13 accommodates the signals from two pickups from a Stick® instrument, where the pickups are wired to the
tip and ring of a standard stereo ¼" TRS (Tip, Ring, Sleeve) plug. You do not need internal preamps when using the SP 13.
1. Slide the Input Wiring switch to the correct position agreeing with your pickup wiring situation.
2. Turn the MAIN OUT LEVEL controls down.
3. Connect the SP 13 to your amplifier using the ¼" MAIN OUTPUTS or use the HEADPHONE jack.
4. Initially, turn the A and B INSTRUMENT GAIN TRIM controls half way up.
6. Move each LOW CUT slider to the top (15 Hz); center all EQ sliders; center the PAN sliders; leave the INVERT
pushbuttons out; and position the LEVEL sliders to “4”
7. Plug in the instrument to the INPUT jack on the front of the SP 13 with a stereo ¼" TRS cable.
8. Power up the SP 13, then turn on your amplifier.
9. Play your instrument and slowly turn up the MAIN OUT LEVEL controls. You should hear sound from your speakers.
If not, recheck all settings and wiring, and read the next few pages.
Never connnect anything except an approved Rane power supply to the red thing that looks like a telephone jack on the
rear of the unit. This is an AC input and requires special attention if you do not have a power supply exactly like the one
originally packed with your unit. See the full explanation of the power supply requirements elsewhere in this manual.
WEAR PARTS: This product contains no wear parts.