Caframo 7802CA-GBX - Manual (Page 4)

How to Use
Place your Work’n Play Sport in a dry location indoors. Set your boots on a flat surface.
IMPORTANT! Before extending tubes: If your Work’n Play Sport has been exposed
to below freezing temperatures, allow it to warm to room temperature before using.
Running the heat setting for 2 minutes will warm the unit and prevent the extendable
boot dryer arms from cracking when being fully extended.
Make sure to shake your boots and gloves out thoroughly of excess water before using
your Work’n Play Sport. Do not allow water to drip into dryer unit in any way. Do not
operate dryer if the power cord shows any damage, or if dryer works intermittently or
stops working entirely.
Fold the boot dryer arms down (pull to click) and extend the tubes. Position the Work’n
Play Sport so that the two boot dryer arms are sitting in the boots. For drying skates, use
the skate clip provided to stand your skates upright.
Fold the glove dryers up and place a glove onto each glove dryer tube. Pressing the
switch, select either the Heat (red) (II) or No Heat (blue) (I) drying option. The No Heat
drying option is recommended for drying delicate leathers and custom footbeds.
Troubleshooting
Symptom Possible Cause Solution
Unit has slight odor
during operation.
Heating element can have odor on
initial operation.
None required - Odor will
quickly disappear.
Unit won’t
operate on “heat”
or “no heat”
setting”.
ALCI plug may be tripped. Press reset button. Plug-in
again - If button pops again
DO NOT USE PRODUCT.
Unit works but
then shuts off.
Dryer is equipped with overheat
protector.
If the internal temperature reaches
75ºC (167°F) the dryer will
automatically turn itself off.
Unplug dryer and let cool
down for 10 minutes.
Ensure all air intakes are
free of obstruction.
Unit blows warm
air on “heat”
setting, but does
not get HOT.
The dryer has been designed to heat
a boot or skate up to an internal
temperature of approximately
104°F or 40 °C, an industry
designated temperature determined
to maintain a boot’s integrity and
protect delicate liner materials.
None required - Normal
operation.
Caring for your Work’n Play Sport
Your Work’n Play Sport has been designed for many years of problem-free operation. The
motor is permanently lubricated and does not require oiling. However, since this dryer
moves a high volume of air, it does require periodic cleaning. Always unplug and turn your
Sport off before cleaning. Use a vacuum cleaner hose to clean the air intakes on the front
grill. Always store your Work’n Play Sport in a dry place.
1)
2)
3)
4)
5)