OFNA Racing 2-Speed, Shoe, OB4 Long 1/10th Scale -- 35017 - Manual

1/10 SCALE 2-SPEED TRANSMISSION SET (Shoe Type) #35017 NITRO OB-4 INSTRUCTIONS
* This professional two speed transmission is only for Nitro OB-4 1/10 Scale OB4 Gas Car Kits.
Nitro Ob4 ASSEMBLY OF THE TWO SPEED GEAR
(45T GREEN and 41T PINK)
35952
45T
Spur Gear
( Green)
35322
1st Gear Carrier
(One-Way)
35933
2.6 X 3mm
Flat Head
Screw
35953
41T
Spur Gear
( Pink )
35321
2nd Gear
Clutch Bell
( Ball Bearing )
* Apply Screw Glue.
* Apply Screw Glue.
Scr
ew
G
lu e
Scr
ew
G
lu e
* Assembly the 1st gear
carrier as shown.
Adjustment
Hole
37550
10x15x4mm
Ball bearing
35326
One-Way
Bearing
35933
2.6 X 3mm
Flat Head
Screw
28 ASSEMBLY OF THE TWO SPEED CLUTCH SHOE
* Screw the M2x10mm screw into
the bottom and back off 5 turns.
M2x10
Screw
M2x10
Screw
6
35329
Spring
35329
M2x10mm
Hex Screw
35329
M3x3mm
Set Screw
35323
Clutch
Shoe
35329
Spring
35329
M2x10mm
Hex Screw
35329
M3x3mm
Set Screw
35323
Clutch
Shoe
35329
Ball
35329
Ball
Sand Paper
* Use a 500 grit sand paper and flat
surface to sand the shoe flat.
Desk
234Z
4 X 4mm
Set Screw
4mm
E-Ring
35324
Clutch Shoe
Carrier
* 2 speed transmission
after assembly.
* Notice the direction of
the gear as shown.
#308F
Clutch Shoe
Carrier
* Put the shoe carrier in
the "D" cut.
Leave 12mm