Cigar Oasis ULTRA 2.0 - Manual

Included in the Box:
Also included is a magnet to attach your ULTRA 2.0 to the lid of your humidor.
ASSEMBLY & STARTING YOUR CIGAR OASIS ULTRA 2.0
1) Remove all contents from the box and remove all plastic wrap.
2) Locate the water cartridge which comes prefilled with distilled
water and remove all tape.
3) Place the cartridge onto the control top until the clip locks into
place.
4) Connect the ribbon cable to the connector with the blue side of
the ribbon down. From the back of the humidor, slide the free
end of the ribbon cable between the hinges and while the Cigar
Oasis is in the humidor connect it to the power port on the side
of the unit with the blue side of the ribbon facing down.
5) Plug the Micro USB connector into the connector at the back of
the humidor and plug the adapter into the wall to power on your
unit.
Cartridge Refill Instructions
1) Fill a bowl with distilled water only and submerge the cartridge
in it for 4 minutes.
2) Take out the cartridge and let it stand on the countertop for
another minute.
3) Empty all remaining water out of the cartridge so only damp
foam remains. **No water should drip out when the
cartridge is held upside down. **
4) Dry off the cartridge and put the unit back together.
USING YOUR CIGAR OASIS ULTRA 2.0

Once the unit is put together and plugged in, it turns on and will
read the current humidity. The unit is factory preset at 70%
humidity. As soon as the humidity drops below 70% the fan will
come on to add moisture to the humidor.

To raise or lower the humidity settings use the UP or DOWN
arrows. A few seconds after the adjustment the unit will go back
to showing the current humidity level.
 When the unit needs to be refilled, it will flash Lo H2O.
By pressing the SUN button you can view the following information:

Press 1 time to view TEMPERATURE. Use Up and Down
arrows to select Celsius or Fahrenheit. To save your selection
press the SUN button again.

Press 2 times to view Average Humidity.

Press 3 times to view LOW Humidity over 3 days (the unit will
start at 0 until it has enough information to give an accurate
reading).

Press 4 times to view HIGH Humidity over 3 days (the unit will
start at 0).
Battery Operation
If you unplug the ULTRA 2.0 or incur a power outage, it will
automatically go on battery power.
Press SUN button 5 times to view battery charge level when connected
to outlet.
Press SUN button 6 times until you see Pon to enter Power Save Mode
(only available when operating on battery power). Use the down and up
arrows to scroll through the Power Options and the SUN button to
select the option.

Pon is Power On.
 SLP is Sleep Mode. The display and fans will turn off. Hold the
SUN button for 3 seconds to turn the unit back on.

PoF is Power Off mode. This completely shuts down the unit
and it will need to be plugged in to turn it back on.
Charging the battery - Plug the ribbon cable into the unit and let it run
on outlet power for approximately 2 hours or until fully charged.
Optional Accessory
Wi-Fi
For instructions on the operation of the Wi-Fi module please refer to the
Wi-Fi manual.
Water
Cartridge
Micro USB Connection
Control Top Ribbon Cable
Connector
Power Adapter