V.I.O. POV.1.5 - Manual (Page 5)

5
The POV.1.5 Recorder
This section explains the details of using the POV.1.5 Recorder to Shoot and Tag
your video. To find out how to Edit and Share your video, refer to the POV Manager
User Guide that appears later in this manual.
Setting up the POV.1.5
Setting up the POV.1.5 is very straightforward. Just connect the camera head to
the POV.1.5 Recorder, install the batteries and SDHC Card, and you’re ready to
start creating video from your Point Of View.
Connecting the Camera Head to the POV.1.5 Recorder
To start setting up the POV.1.5, connect the tethered camera head to the POV.1.5
using the digital A/V cable. Be sure to only twist the grooved metal barrel of the
connector.
The digital A/V cable connector has a small notch in it so that it will only plug in
when aligned properly. Do not force the connector since doing that may damage
the connector pins. Once you plug the cable into the recording unit you then need
to turn the metal ring to screw the cable in place and secure the connection.
The Tethered Camera Head.
Protecting the POV.1.5 Recorder Display
In order to protect the POV.1.5 Recorder’s LCD screen from scratches the POV.1.5
comes with an LCD protective cover, which is a small plastic sheet that is used to
cover the screen.
To install the LCD protective cover:
1. The POV.1.5 is shipped with a plastic sheet covering the display. If this is still
on the unit remove it.
2. Make sure the LCD screen is clean and free of any dust, smudges, fingerprints,
etc.
3. Peel the paper off the back of the sheet and position the plastic sheet over the
LCD and press it down to secure it.
4. Use your finger to smooth out any air bubbles that may be trapped.