Belt Drives EVO-12S - Manual

3" ELECTRIC START DRIVES FOR DYNA MODELS
(Kit Number: EVO-12S)
Be sure to read the Warranty , Introduction , belt tracking and starter gear problems , alignment procedure and
disconnect battery.
1. Remove inner primary.
2. Remove exhaust to allow access to the swing arm
pivot bolt. (Fig.1)
Fig.1 Remove exhaust to allow access to the swing arm pivot
bolt
3. Remove castle nut on pivot bolt to allow pivot bolt
to be removed. (Fig. 2)
Fig. 2 Remove castle nut on drive side to allow pivot bolt to be
removed
1