Belt Drives TF-2000 - Manual

TF-2000 INSTALLATION FOR OUTBOARD SUPPORT
IMPORTANT UPDATE AND PRODUCT CHANGE
BDL items EVO-900 Series 3" Belt Drive with Outboard Support, EVO-3000 Outboard Support Retro Fit Kit and
TF-2000 have been changed.
We have eliminated the front pulley and engine shaft support and front bearing of the outboard support.
The reason for this change was due to the many aftermarket components that come together on a special
construction motorcycle, we find that a lot of these components do not allow proper alignment of the entire
motorcycle.
When using an outboard support that was intended to keep the front engine and rear transmission shafts from
moving excessively, improper alignment will cause unusual wear and premature failure of the sealed bearings.
By supporting only the rear shaft, which is all that is really needed, we have eliminated any potential problems
that mis-alignment may cause.
Lightly grease bearing race of front and rear bearings, for ease of installation, and slide support onto pulley covers.
1
Install front and rear pulley covers. It is suggested that the bolts be secured with Loctite®.