Fm radio – Sangean WFR-28C (V1) User Manual
Page 56
55
FM Radio
Operating your radio in FM mode
. Carefully extend the telescopic aerial and press the
Standby button to switch on your radio.
2. Press the
Mode button and rotate the Tuning Control Rotary as needed to highlight FM radio
mode. Press the
Tuning Control Rotary to select the option.
. Rotate the
Tuning Control Rotary in a clockwise direction. The displayed frequency will increase.
Press the
Tuning Control Rotary to carry out an auto-tune. Your radio will scan up the FM band
from the currently displayed frequency and will stop scanning when it finds a station of sufficient
strength.
4. The display will show the frequency of the signal which has been found. If RDS information is
available, after a few seconds the display will show the radio station name. If you only hear hiss
or interference, simply press the
Tuning Control Rotary to scan further. Your radio may have
found a spurious interference signal.
5. To find more FM stations press the
Tuning Control Rotary to repeat the scan operation. To scan
down in frequency, rotate the
Tuning Control Rotary in a anti-clockwise direction first and then
press the
Tuning Control Rotary. Your radio will scan down the FM band from the currently
displayed frequency and will stop scanning when it finds a signal of sufficient strength.
6. When the end of the waveband is reached your radio will recommence tuning from the opposite
end of the waveband. Use the Volume buttons to adjust the sound level as needed.
1
2
6
3-5
FM
radio
104.90MHz
FM
10:38
FM Radio
V.H.B.N.
FM
10:39
FM Radio