Sangean WFR-28D (R2) - Manual (Page 77)

76
GB
Network profiles
Each time that you connect your radio to a WiFi network, the radio will store the details of that
connection (SSID, security key, DHCP/IP address settings) as a profile. Up to four such profiles
are stored in the radio so that if the unit is used in multiple locations there is no need to enter the
network settings when returning to a location previously visited.
The radios stores the four most recent profiles in memory identified by their SSID. Normally the
radio will attempt to connect to one of the stored profiles and only if it is unable to do so will you
need to use the Network Wizard.
In the event that you visit a location only once you may wish to delete the profile for the network
in that location to avoid losing other profiles.
1. Access the menu for the current mode by pressing the Menu button. Rotate the Tuning Control
Rotary until 'System settings' is highlighted on the display. Press the Tuning Control Rotary
to enter the settings menu.
. Rotate the Tuning Control Rotary until 'Network' is highlighted on the display. Press the
Tuning Control Rotary to enter the Network settings menu.
. Rotate the Tuning Control Rotary until 'Network profile' is highlighted on the display. Press
the Tuning Control Rotary to see the stored profiles. The profile which is currently in use (if
any) is marked with an asterisk.
4. To remove a profile from memory, rotate the Tuning Control Rotary to highlight the profile to
be deleted and then press the Tuning Control Rotary to confirm the setting.
5. The radio will offer a 'YES' or 'NO' selection. Rotate the Tuning Control Rotary to select 'YES'
and then press the Tuning Control Rotary to confirm the setting. The selected profile will be
deleted.
Note: that it is not possible to delete a profile which is currently in use.