Sangean ATS-909 w (V1) - Manual (Page 6)

d. SNOOZE ICON
e. SLEEP TIMER ICON
f. TIMER
g. RADIO WAKE-UP
h. HWS BUZZER WAKE-UP
i. SELECTED TIMER
j. BATTERY SYMBOL ICON
k. SIGNAL/BATTERY LEVEL
l. ROTARY TUNING SPEED
m. STATION/CITY
n. FREQUENCY
o. RDS SYMBOL
p. FM STEREO INDICATOR
q. MEMORY LOCKED
r. MEMORY PRESETS
s. PAGE
t. BAND SELECTED
u. AM MODE SELECTION(AM,LSB,USB)
v. SW METER BAND
w SYSTEM LOCK
x. DIGIT FOR MEMORY SLOT
POWER SUPPLY
The ATS-909 operates on 4 AA Batteries. If an external adapter is used it must be capable of providing
6.0VDC,300ma. With center connector negative.
CHANGING BATTERIES
Press and remove battery cover in the direction as indicated by the arrow on the cover.lnsert 4 AA
batteries with polarities exactly as shown on diagram next to battery cover. Side battery cover back into
place in direction of arrow until case snaps into place.
Each time the ATS-909 is turned off the battery icon and battery level indicator will remain on for
approximately 7 seconds.Batteries should be replaced when level indicator drops to 2/and or the
battery symbol flashes.
Batteries must be replaced within 3 minutes to retanin clock display.(Input memory will remain intact
even during power failure because receiver is equipped with EEPROM memory)
USING EXTERNAL AC ADAPTER
The ATS-909 can be used on AC by using the Sangan AC Adapter included with this radio. When
connected the batteries within the radio will be automatically disconnected.
SETTING THE CLOCK(REAL TIME)
In keeping with wold wide short wave protocol time is programmed on a 24 hour basis. (Greenwich
5