Talkaphone CU-8R Area of Rescue Flush Mount Command Unit - Manual (Page 2)

CU-8 Installation Instructions
Copyright 2012 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 2 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
9) Place the two batteries on the shelf inside the enclosure, below the power source. Connect
the cable from the “BAT” terminal point on the power source to the two batteries (Red cable –
positive to the positive of one battery and Black cable
– negative to the negative of the other
battery. The two batteries are connected in series via two quick disconnect terminals on either
end of the cable).
10)
Place cover over enclosure and re-secure with screws removed in step 1.
III. Programming
1) Program EC-8 per Instructions packed with that unit. Be sure the EC- 8 is set for “LOCAL
PHONE ONLY” operation or “LOCAL/TELCO” alternation if an outside phone line or a PBX
line is used in the system.
2)
Program each Emergency Phone per Instructions packed with that phone. Be sure to
program feature *78* in addition to any other features selected. NOTE: If no outside phone
line or PBX line is used, program the number to be called as *13*5551234*. This is
necessary for proper system function.
Strobe/Siren Assembly