Talkaphone ETP-MT/R AED Defibrillator Emergency Phone Tower - Manual (Page 4)

ETP-MT/R OP SOLAR Tower Installation Instructions
Copyright 2009 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Page 4 of 5
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
DC/DC converter can be mounted inside the tower below the Cellular Device using the attached
double-sided Velcro.
12. Install the shelf and battery and make all remaining connections, including connecting the
batteries in parallel with the provided connector cable. NOTE: IT IS ESSENTIAL THAT THE
BATTERIES ARE CONNECTED IN PARALLEL AND NOT IN SERIES OR DAMAGE WILL
OCCUR TO THE SYSTEM.
13.
Connect the black and orange wires of the Emergency Phone to the black and orange control
wires of the blue light/strobe. These are the AUX 2 output leads (see Emergency Phone manual
for programming). Plug the RJ11 connector on the emergency phone into the Cellular or other
communications device. Attach the Emergency Phone to the tower with six (6) 10-24 oval head
tamperproof screws.
14. Re-attach the cover plate over the access opening.
IV.
ETP-MT/R OP SOLAR Wiring Diagram