Talkaphone KB-LC-2 Single Channel Master User Manual

Kb-lc-2 installation and operation instructions

Advertising
background image



KB-LC-2 Installation and Operation Instructions

Copyright 2009 Talk-A-Phone Co. All rights reserved.


Talk-A-Phone

Co.

• 7530 North Natchez Avenue • Niles, Illinois 60714-3804

Rev. 7/28/09

Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com

All prices and specifications are subject to change without notice.

Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.

INSTALLATION

Set up the Master Station and the Sub-Station in the desired locations. Run a length of Talk-A-Phone
#6303 (3-conductor shielded) cable between the Master and the Sub-Station. Connect wire of
corresponding color to same terminal number on both Master and Sub-Station.

Underneath the Master and Sub-Station is a cable clamp. Remove screw on cable clamp and pass
interconnecting cable underneath clamp. Adjust cable clamp so that it holds cable securely, and replace
screw.

The Master Station is powered by a separate power supply (included), which connects to the “+” and “-“
terminals on the terminal strip on the bottom of the unit. The black wire on the power supply connects to
the “-“ (minus) terminal, and the black with white stripe wire connects to the “+” (plus) terminal. Should
your installation require grounding of the unit itself, you can connect a ground wire to the “G” terminal on
that terminal strip. The power supply cord should be routed through the strain relief on the bottom of the
chassis.

Care should be taken that no part of the cable is too near electric or telephone wiring, etc., nor should it
be shorted to any grounded conductors, radiators, pipes, beams, etc., and the bare wire at the various
terminals should not short from one terminal to the other nor the metal chassis. When staples are used to
hold the cable in place, use only insulated staples and do not drive them in so hard as to cause the wires
inside the cable to short to each other.

CONTROLS


VOLUME CONTROL:
Located at the left of the cabinet on the Master Station only. Rotate clockwise to
increase volume.

TALK-LISTEN CONTROL: Located on the right of the cabinet, (left on the K-LR-3W). Basically, push in
to “talk”; release to “listen”.

TRANSLUCENT INDICATOR: Located to left and below volume control knob on Master Station.
Indicates that unit has power.

Advertising