Talkaphone WEBS-MT/R Radius Emergency Phone Tower with WEBS - Manual (Page 7)

WEBS-MT/R Tower Installation Instructions
Copyright 2014 Talk-A-Phone Co. All rights reserved. Page 7 of 9
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
IV. Wiring Installation
1. Make all connections to the DIN Rail Terminal Block as shown in Table 1.
2. Connect the Paging Amplifier to the WEBS Loudspeakers, DIN Rail Terminal Block and the WEBS-
VCU as shown in Figure 4. Connect the speaker audio cables to their corresponding paging amplifier
speaker output cables as follows:
PAGING
AMPLIFIER
Power
Connections
Power - [RED]
Power - [BLACK]
Trigger – [ORANGE]
POWER CABLE
[RED or WHITE]
[BLACK]
TRIGGER CABLE
[WHITE]
[ORANGE-
WHITE]
[RED or WHITE]
[BLACK]
[WHITE]
[ORANGE-
WHITE]
55
50
37
36
}
To DIN Rail
Terminal Block
Audio
Output
Audio
Input
[PURPLE]
[GREEN]
[GREY]
[WHITE] {
To Speaker
Cables
RCA Cable 1
RCA Cable 2
RCA Cable 3
RCA Cable 4
}
To Audio Output on
WEBS-VCU
Figure 4. Paging Amplifier, WEBS Loudspeakers, WEBS-VCU and DIN Rail Terminal Block Connectivity Layout
Speaker No. Amplifier Cable
Speaker #1 White and White/Black
Speaker #2 Grey and Grey/Black
Speaker #3 Green and Green/Black
Speaker #4 Purple and Purple/Black