Talkaphone WEBS-WM Wall Mount Emergency Phone Station with WEBS - Manual

WEBS-WM / WEBS-WM-12 Wall Mounts
– Installation Instructions
Copyright 2012 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714-3804 Rev. 7/6/12
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
I. Introduction
Model WEBS-WM / WEBS-WM-12 Wall Mount units are designed to house the Talk-A-Phone Blue Light; paging
amplifier and horns; and a Talk-A-Phone 400-Series or 500-Series ADA compliant hands-free Emergency Phone.
In addition to the Emergency Phone Station, this unit is designed to work as part of a Wide-Area Emergency
Broadcast System.
II. Installation
To install the Wall Mount, after site preparation (including telephone/data line and provision of power for the Blue
Light and faceplate light), follow these steps:
1. The Wall Mount is held to the wall with 4 #10 screws. Install two #10 screws in order to hold the top
section to the wall. Note that the screws should be located so that the Wall Mount will be at the
desired height and in the correct position to receive any conduit connections.
2. Electric power and the telephone/data line can be brought into the unit in one of two ways:
a. There is one large opening in the back of the unit to allow the unit to be mounted over a flush
mounted standard electrical outlet box and/or flush mounted telephone connector box.
b. There are two conduit openings available on the bottom of the unit to feed the power and/or
telephone/data line inside the unit (Note: Power and telephone/data lines cannot be ran in same
conduit).
3. Remove the cap lid from the Wall Mount by removing the four #10 spanner security screws located on
the side of the unit. DO NOT remove the Lexan shield from the unit. Mount the unit on the wall using
the two keyholes on the top rear of the unit to the two screws mounted to the wall in step 1.
4. Install two additional #10 screws of the appropriate type in the holes in the lower rear of the unit.
Tighten all four screws.
5. Install conduit over the bottom hole(s) of the unit if method (b) is being used (see step 2) and bring
power line and/or telephone/data line inside the unit.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION
PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LES PRODUIT ET
SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS