Kidde i12010S - Manual (Page 14)

Step 4
Testing the Alarm
CAUTION: Due to the loudness (85 decibels) of the
alarm, always stand an arms length away from the unit
when testing.
After installation, TEST THE UNIT’S ELECTRONICS by pressing and
releasing the test/reset button. You will hear one beep on the
button push, and will then hear the
following sequence of "beeps:
Three long beeps.
Pause
Three long beeps.
Pause
Single beep to reset
Weekly testing is required! If at
anytime it does not perform as
described, verify power is connected
correctly. Clean dust and other buildup
off the unit. If it still doesn’t operate properly call the Product
Support Line at 1-800-880-6788.
Interconnect Feature
Your Smoke Alarm is interconnectable to other multiple station
Kidde, Nighthawk and Kidde/Fyrnetics products:
• When mixing compatible models with battery backup with models
without battery backup, be advised that the models without battery
backup will not respond during an AC power failure.
• This unit is only approved to interconnect with other
Kidde/Nighthawk products. It is NOT approved to interconnect
with any other brand of detection product.
• This alarm is interconnect compatible with the following alarms
and accessories:
–Smoke alarms: 1235, 1275, 1276, 1285, i12020, i12020A,
i12040, i12040A, i12060, i12060A, i12010SCO, i12010S,
i4618, i4618A, KN-SMFM-I, RF-SM-ACDC, PE120, P12040,
Pi2000,
Pi2010, i12080, i12080A, KN-COSM-I,
KN-COSM-IB, KN-COSM-IBA
– Heat alarm: HD135F
– CO alarms: KN-COB-IC, KN-COP-IC, KN-COPE-I
– Relay modules: SM120X, CO120X
– Strobe Light: SL177i, SLED177i
Installation Instructions
12
FIGURE 4
Installing AC Quick
Connect
!
1210-7201-01(i12010S)_V3.qxd:_ 2014.2.20 3:19 PM Page 14