GiiNii GN-5LS - Manual (Page 15)

15
Step 3: Using the calibration paper
1. Insert the calibration paper with the white side DOWN into the feed
slot.
2. Press MENU (
MENU
) button to bring up the System Menu.
4. Select OK
OK
) to begin the calibration process.
Note: The process will take few minutes to fi nish, and then shut down
automatically. Please turn the power back on again.
3. Align the feed slot cover. Assembly the edge’s two latching tabs with
the mounting holes on the scanner. Push the cover back in until it
clicks in place.
3. Press LEFT ( ) /RIGHT ( ) button to select Setup ( ) button then
press UP ( ) /DOWN ( ) button to select “Calibration”.