Beckett 61847 Combination Control - Manual

52199 AquaSmart
®
/ GeniSys
®
Combination Control
R8182H Replacement Kit
Installation Instructions
This control package is intended to replace the Honeywell R8182H triple acting Aquastat ®* . Please read the supplied
literature for the GeniSys burner control (61649) and AquaSmart boiler control (61738) before beginning the installation.
1. Make sure power is turned off to the heating system.
2. Record all R8182H temperature limit and differential
settings for reference.
3. Remove and mark all wires terminated in the old
control.
4. Remove necessary conduit from the boiler control.
5. Carefully remove the boiler control from the immersion
well.
6. Inspect and clean the immersion well, preparing it for
the installation of the AquaSmart temperature sensor.
(See AquaSmart literature (61738) for details)
7. Mount the AquaSmart control to the immersion well,
per instructions outlined in the AquaSmart Manual.
8. Mount the 4x4 box extension with the burner control to
the 4x4 box on the oil burner, or to an accessible 4x4
box near the appliance.
9. Wire the unit as appropriate for your system
requirements. See the available options in the
enclosed AquaSmart literature pages 12-24 and
GeniSys literature for burner component wiring.
10. Turn power on. Program AquaSmart to desired
temperature and differential settings.
11. Observe a complete call for heat cycle to ensure the
control performs all programmed functions and shuts
off at set temperature.
INCLUDED PARTS:
(1) AquaSmart Control, Part No. 7600A001
(1) GeniSys Control, Part No. 7505A0000
(1) Wire Harness 1, Part No. 52193 (5 wire)
(1) Wire Harness 2, Part No. 52194 (4 wire)
(1) 4x4 Box Extension, Part No. 32778
(1) 48” Sensor Extension, Part No. 5212001
Explosion, Electric Shock,
Burn and Scald Hazards
Excessive water temperatures could cause
explosion, burns, scalding, pressure relief
fl ooding and fi tting leaks.
For proper installation, follow the steps outlined below.
Part No. 61847 R01, Printed in the USA
02/12
R.W.
BECKETT
CORPORATION
P.O. Box 1289, Elyria, Ohio 44036
R.W. BECKETT CANADA, LTD
430 Laird, Unit 3, Guelph, Ontario, N1G 3X7
All necessary wires labeled and
located under the 4x4 box extention
*Aquastat is a registered trademark of Honeywell International, Inc.