Canon CS-S 4.3 - Manual (Page 24)

CONTENTS
GLOSSARY
INDEX
24
24
Chapter 3
Scanning
Specifying How the Image is Previewed
Before you scan or preview, you can change the mode and specify how the
image appears in the acquiring application.
To specify how the image is previewed:
1. Choose the Scan Mode that best matches how you want the scan of the
object to be output.
Note: If you have already scanned an image and then change the
scan mode, the image is cleared from the preview area, and
you lose your preview image and all the settings you have
made.
2. Specify the Scan Resolution that best matches how you will be using the
scanned image.
3. Specify Width and Height of the platen area to be scanned if you want an
area other than the full platen scanned. Specify Units if other than the
default.
To keep the width to height ratio (proportion), click the Keep Proportions
button before changing the width or height values.
4. Change the Scale from 100 percent to either enlarge or reduce the
scanned image. The new Output size (width and height times the scale
factor) is displayed to the right of the Scale text box. To set the scale,
either click the up or down arrows or click in the field and type a
percentage.