Beckett GeniSys Contractor Tool - Manual (Page 5)

Page 5
Pressing the BACK (NO) key at this
stage will return the display to the
VIEW HISTORY screen. Pressing
the PREV key will display the hours
since the screen was last cleared.
Pressing the NEXT key will display
the Lifetime Cycle Count screen. Note
that the data associated with the
Cycles and Hours Since Cleared
parameters (First 2 screens) is
stored on the display module. To log
this information the display must
remain connected to the control.
◄
PREV


From this screen, pressing the BACK
(NO) key returns you to the VIEW
HISTORY screen, and pressing the
PREV key displays the cycles since
last cleared screen. To reset/clear the
hours, press and hold the SEL (YES)
key for 3 seconds and respond YES
to the CLEAR COUNTS? prompt.
◄
PREV


From this screen, pressing the BACK
(NO) key returns you to the VIEW
HISTORY screen, and pressing
the PREV key displays the Lifetime
Cycles screen. To reset/clear the
cycles, press and hold the SEL (YES)
key for 3 seconds and respond YES
to the CLEAR COUNTS? prompt.
3.
4.
5.
◄
PREV


Pressing the BACK (NO) key at
this stage will return the display
to the VIEW HISTORY screen.
►
NEXT


From this screen either press the
BACK (NO) key to return to the View
History screen or press the SEL (YES)
key to display a single parameter’s
readings through the 15 burner
cycles. For example, to display the
Run Time for all 15 cycles, press SEL
(YES) and use the SEL (YES) and
BACK (NO) keys to scroll through
the Run Time for all 15 burner cycles.


SEL
(YES)


SEL
(YES)
6.
7.