Warning – Coleman 2300-700 User Manual

Page 5

Advertising
background image

To Set Up

cont.

• Installation of propane cylinder in Hot Water on Demand

TM

.

Use standard propane cylinders made for camping products.
Do not use 14.1oz cylinders normally used for hand torches.
Do not use MAPP gas cylinders or any other fuel except propane.
Make sure the control knob is turned “OFF ”.
Push in on the propane access door latch that is located on the left side of the door and swing door to opened position.

Remove cap from propane cylinder but do not discard.
While holding the propane cylinder upright, attach it to

the REGULATOR located inside the door by turning
clockwise. Be careful not to cross-thread, hand tighten
only.

Open the Propane Access Door.

Remove propane cap.

Install the propane cylinder.

• Check for Propane Leaks

Make 2 to 3 oz. of leak check solution (one part liquid dishwashing

detergent and three parts water).
Apply several drops of solution at the connection between the propane

cylinder and the regulator. (Fig. 2)

Bubbles indicate a leak.

Check that the connection is not cross-threaded and that it is tight.
Perform another leak check. If there is still a leak, remove the cylinder

and contact Coleman for services or repair.

WARNING

• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use Hot Water on Demand

TM

until connection has been

leak tested and does not leak.

5

WARNING

• If using refillable propane cylinder, the LP-gas cylinder(s) must be

constructed and marked in accordance with the specifications for
LP-gas cylinders of the U.S. Department of Transportation or
Transport Canada, CAN/CSA B339. Use only Coleman® acces-
sories or parts. During heater set-up, check all hoses and fittings
for leaks using soapy water. Never use a flame. Always keep refill-
able cylinders outdoors, never inside house, camper or tent.

Fig. 2

Advertising
This manual is related to the following products: