C. Crane Witness Plus - Manual (Page 3)

7. Remove the old battery,
along with the tape.
8. Before laying the unit face-
down on a surface, first
lay down a soft cloth to avoid
potential damage to the dis-
play screen. Using a pair of
needle nose pliers, remove
the connector by gently pull-
ing it towards the bottom of
the case. Be careful not to
put extreme pressure on the
plastic connector with the
pliers or you may damage it.
9. Insert the new battery in the
same fashion. Be sure that
when reinserting the new
battery connector that the red
wire is positioned on the
right, as shown in the picture.
Inserting the connector
should not require a great
amount of force.
10. Arrange the excess wire be-
tween the battery and the
gray speaker wall as shown
in the picture at right. Reap-
ply the tape to the battery
and position the back cover
correctly over the front cover.
Be sure both are aligned
properly.
3