C.R.Plastic Products C23 - Manual

Product: Bar Stool (C21)
Your purchase and who is C. R. Plastic Products Inc.?
Parts You will need:
1. Two sets of legs. (A) 1. Drill
2. Two small stringers (B)
3. Two medium stringers (C)
4. Two long stringers (D)
5. Seat ( E )
6. Bag of screws (28 - 2½")
NOTE: The stringers (B, C, D) have angled cuts, the short side
faces the seat of the stool.
Step 1: Take one set of legs (A) and the small stringers (B). Hold one
stringer flush to the top of the leg. Using the pre-drilled holes on the
leg, fasten the stringer with two 2½” screws. Repeat on the other side.
Step 2: Take one of the medium stringers (C) and place it at the middle
set of holes, Screw it into place using two 2½” screws. Take one of the
long stringers (D) and place it at the two bottom holes. Screw it into
place the same way you did above.
Repeat on the other side.
Step 3: Take the second set of legs, and fasten them onto the stringers
with six 2½” screws.
Step 4: Place the seat (E) upside down, with the square frame facing
up. Place the legs on top of the frame, making sure the holes on the
stringers are centered on the frame. Screw the stringers to the frame,
using the remaining screws.
C. R. Plastic Products Inc. is an environmentally conscious Canadian company. Our "Generation Line" of recycled
plastic furniture will give you years of comfort, style, and maintenance free enjoyment. You will find your furniture to be
waterproof and durable. By choosing this product you are saving generations of trees and are reducing the burden on
our landfill sites. Thank you for purchasing from C. R. Plastic Products Inc.
2. #2 Robertson
(square)
or Phillips bit
Proudly Made In Canada