CANOGA PERKINS L312 Ethernet Media Converter - Manual (Page 26)

EdgeAccess Universal Chassis System
L312 Ethernet Media Converters 4-8
Table 4. System Configuration Option Definitions
Selection Description
1) Reset Unit Reset this CLIM without interrupting other devices in the chassis
2) Reset Configuration To Default Restore the factory settings
3) Option Control Hardware or software control for LLE, LLF, and Alarm Output.
When set to Hardware, you must set SW1 on the L312 board
because the system does not then accept changes in software. For
details, see Chapters 2 and 3.
4) Link Loss Echo Enable or disable LLE
5) Link Loss Fwd Enable or disable LLF
6) Alarm Output Enable or disable the alarm output
4.6 Trap Configuration
Traps are messages to alert network management about conditions. The DMM logs the traps and
transmits them by SNMP to the network manager. At the Trap Configuration screen, enable or
disable traps individually or use the "Master Trap Control" to enable or disable all traps. See
Figure 15.
To configure traps:
Step 1. From the Main Menu, type 2, Trap Configuration, and press <Enter>.
Step 2. At the Trap Configuration screen, type the number for a trap and press <Enter>.
Note: "Master Trap Control" enables or disables all traps. The factory default is Disabled.
Step 3. Press <Space> to cycle to Enabled or Disabled and press <Enter>.
Figure 15. Trap Configuration Screen