CANOGA PERKINS CanogaView Smart Element Manager - Manual (Page 36)

CanogaView
®
Smart Element Manager
Next, the CanogaView Smart Element Manager Login screen opens and the user will be
prompted to enter a username and a password.
Figure 3-9. Login Screen
3.2.3 Login
The standard login screen, shown above, will appear the first time access to any
CanogaView Smart Element Manager application (e.g. Agent Chooser, Domain View, 9135
View, Alarm Monitor, etc.) is attempted. After a successful login, any application may then
be accessed without having to enter a username and password. The login session
continues until the user explicitly logs out or the session times out due to inactivity.
If the password for CanogaView has not been established, enter "guest" or "admin" as the
username and password. This entry is case sensitive. After a successful login, the Agent
Chooser screen will open.
The Account Manager Utility application is used for username and password management.
See section 3.3.1 for more information on how to use the Account Manager application.
3.2.4 Agent Chooser
The CanogaView Smart Element Manager’s SNMP Agent Chooser application (see Figure
3-10) must be used to add each managed SNMP Agent to its database. CanogaView Smart
Element Manager must know the IP Address and Agent Type of the SNMP Agent so that
the correct management applications are used to access and retrieve data from the
managed device using the SNMP protocol and device specific MIB variables.
Additionally, it is essential that the IP address of the server on which the CanogaView Smart
Element Manager Standalone software is installed must be added to the SNMP Agent’s host
table for each device that is to be managed. Additionally, if trap/alarm monitoring is desired,
then the appropriate “access level” and “trap port” must be setup. See Figures: 1-1 and 1-2
in this manual for examples of the DMM and 9135’s user interface.
The SNMP Agents currently supported are:
28 Standalone Version