CANOGA PERKINS 9175 Configuration Guide - Manual (Page 168)

CanogaOS Configuration Guide
26-1
26 Configuring LDP
26.1 Overview
This chapter describes how to configure LDP.
A fundamental concept in MPLS is that two Label Switching Routers (LSRs) must agree
on the meaning of the labels used to forward traffic between and through them. This
common understanding is achieved by using a set of procedures, called label distribution
protocol -LDP. The CentecOS software supports these features:
• Downstream unsolicited label distribution with liberal retention mode.
• Supports control-mode modification.
• Supports lsr-id and transport-address modification.
• Supports target peer setting.
• Supports outbound label filtering.
• Supports explicit null label
This configuration guide will describe the basic configuration of LDP in our system and
give some examples for it.
More information about LDP, please see RFC3031 and FRC3036.
26.2 Set up LDP connection
Configure lsr-a
Beginning in privileged EXEC mode, follow these steps to configure the LDP:
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the interface
DUT1(config-if)# no switchport Configure the port as route port.
DUT1(config-if)# ip address
11.11.17.1/24 Create IP address on the port.
DUT1(config-if)# enable-ldp Configuring Interface for LDP
DUT1(config-if)# label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Configure mode.
DUT1(config)#router ldp Enter the router-ldp mode
DUT1(config-router)#exit Exit the router-ldp mode
DUT1(config)#router rip Enter the router-rip mode
DUT1(config-router)#network
11.11.1.1/16 Configuring the port as layer 3 port.
Configure lsr-b
Beginning in privileged EXEC mode, follow these steps to configure the LDP:
Command Description