CANOGA PERKINS 2346 T3 Modem - Manual

Copyright ã 2003 Canoga Perkins Corporation. All Rights Reserved. 6942680 Rev. A
2346 T3 Modem Quick Start Guide
To set up and install the 2346 T3 modem, follow these steps:
1. For installation in a UCS 1001 or standalone enclosure, or if you plan to use the
Software Override option (see the User Manual), set SW2-2 to On to enable line
buildout or Off to disable line buildout.
SW2
2. Slide the 2346 into a slot:
· In the UCS 1002 chassis or a standalone enclosure, slide the 2346 into the slot and
tighten the captive screw.
· In a UCS 1000 or 1001, slide a Model 1230 BAM into a slot in the chassis, then slide
the 2346 into the BAM and tighten all captive screws.
The module automatically receives power from the chassis.
3. Connect cables; use Tx to Rx and Rx to Tx configuration:
a. Plug in BNC cables.
b. Clean optical fiber.
c. Plug in optical fiber.
d. Label all cables with connector name, signal name, and direction.
4. To use the software, go to the Model 2346 T3 Modem User Manual.