Daiwa SEABORG-500Fe - Manual (Page 9)

7
JIG/PICKUP BUTTON
Selection between pickup and jigging can be done in the mode setting display.(One of them should necessarily be chosen.)
Pickup
-You can wind only while pressing this button. This function is useful to wind up line slack and attract fish.
- Winding speed can be changed with the mode setting display. (Default setting is speed 15)
Jigging
- Jigging can be ON/OFF.
- Pressing this button starts jigging. (Display shows )
- Pressing the button again stops jigging.
Mode display
- This display allows you to change setting of each function.
- The functions that are set to work are shown on the display.
(Default setting is speed 15, but the speed can actually be set between 0~Hi.)
Chumming timer (Power indicator, time to wind up, timer display)
- The chumming timer appears when motor rotation is stopped.The timer display cannot be set to OFF.
- Indicates winding speed (winding power) while the motor is running.
Display Function
Chumming timer starts working.
Auto Line feeding is employed. Default setting is off.
Pressing the RESET BUTTON makes this indicator appear, telling you auto
stop will work.
Names of the buttons and the display
5
9
4
Depth counter
- It shows the depth from the surface.
6
7 Inverse counter
- This counter shows the depth from the bottom (or a certain depth).
- The shelf at which the Live line alarm has sounded will be indicated in blinking while Live line mode is ON.
- Once this counter is turned on, its display cannot be turned off.
Jigging display
- This is appeared only when the jigging function is on.
- It blinks when jigging is in process.
(While the depth indicator is shown, the lamp will not light up even when it is set.)
8
Pressing the JIG/PICKUP BUTTON makes the function work. Pressing the
button again stops it.
mode is ON.
The alarm will sound when a move quicker than a preset range is detected
while the clutch setting is OFF.
The alarm sounds every time 1 m of main line is extracted while the clutch
setting is OFF.
Display Function