Citronic Q-MIX2 - Manual (Page 3)

172.800UK User Manual
1. Input for channel 1, XLR + 6.3mm combo jack for balanced mono input.
2. Channel 1 input impedance selector, press down for high impedance input signal to increase
signal to appropriate level. For line input leave switch up.
3. Input for channel 2/3, 2 x AUX input can be used for stereo left/right input or 2 x mono input.
4. Main output from mixer, 2 x AUX output, left and right channel.
5. Monitor output, 6.3mm stereo jack output from mixer, suitable for headphone and desktop
monitoring.
6. Channel 2/3 level control, a rotary control to control the level of channel 2/3 input. Ensure
switch is point at “MIN” when set up and gradually increase to desired level.
7. Channel 1 level control, a rotary control to control the level of channel 1 input. Ensure switch is
pointed at “MIN” when set up and gradually increase to desired level.
8. Signal peak indicator for channel 1, the red LED lights when the signal hits the maximum output
level. In this instance, reduce channel 1 level control and check if correct impedance is selected
to avoid damage to output unit and unwanted distortion.
9. Power indicator, green LED lit when unit is powered up.
10. Phantom power indicator, red LED lit when phantom power is switched on for channel 1.
11. Monitor level control, a rotary control to adjust the level of monitor output. Ensure that this
switch is pointed at “MIN” when set up and gradually increase to desired level to avoid damage
to the monitor unit.
12. Main output clip indicator. This LED lights when the signal hits max output level at the onset of
clipping. In this instance, reduce the level on the master fader to avoid unwanted distortion and
damage to any connected equipment.
13. Master level control, a rotary control to control the level of main output. Ensure switch is
pointed at “MIN” when set up and gradually increase to desired level.
14. Phantom power switch, press down to switch +18Vdc on for XLR input.
15. USB input/output switch, USB operates as an output normally, press down to switch USB to an
input and assign signal to channel 2/3. USB operation requires compatible computer hardware
and operating system of Windows® 2000/XP, Vista, 7 or Mac OS X.
Connecting up:
To power up the unit, a USB A to USB B lead will be required. Plug USB B to the back of the unit and USB
A to laptop, PC, Mac or any other USB power supply. When connecting to laptop, PC or Mac, Q-MIX2
should be auto recognised as an external USB sound device, which allows audio to play into the mixer
through USB. If no response, please check USB diver is up to date and USB sound device is enabled on
your operating system.
To use Q-MIX2 as output to computer through USB, DAW software suite is required to allow audio signal
in from the USB.
To connect any active monitor or amplifier to the mixer, always ensure the monitors or amps are turned
FULLY down before making connection or disconnection. This is to avoid possible distortion and damage
to the output devices.