Dillon FI-80 - Manual (Page 12)

A11
(LCD version)
Peak-Hold
Mode
Enables “Peak Hold” mode. The display will only increment upward
and the peak reading is retained. Press PEAK key to enter and exit
the mode once active.
“0” = Peak Hold disabled, “3” = Peak Hold enabled
Note: UNITS are locked in default when A11 is enabled.
0
√
3
A12
(LCD version)
Handshaking Enables hardware handshaking for Print Ticket Mode. Valid only
when A6 is set to “1”.
"0" = Disable Handshaking "1" = Enable Handshaking 0
√
1
A13
(LCD version) Not presently used. Keep parameter on 0.
0
√
1
USER MENU PROCEDURES
This section provides instructions for some parameters.
ID Number Entry (A8)
1. Scroll to "A 8" and press the key.
2. The display will momentarily show "ID NO", followed by a value with one flashing
digit. This value will be the current ID number value.
3. Use the four directional keys to adjust the displayed value to the actual ID Number
value. Increase and decrease the flashing digit by pressing
or . Decrease
the flashing digit by pressing the ZERO key. The and keys will change the
position of the flashing digit.
4. After entering the exact value, press the Set key to save the ID Number value. The
display will show "SET" momentarily and revert back to A8.
LF (Line Feeds) Number Entry (A9)
1. Scroll to "A 9" and press the key.
2. The display will momentarily show "LF", followed by the current line feeds value.
3. Use the four directional keys to adjust the displayed value to the actual ID Number
value. Increase and decrease the flashing digit by pressing
or . Decrease
the flashing digit by pressing the ZERO key. The and keys will change the
position of the flashing digit.
4. After setting the exact value, press the Set key to save the line feeds value. The
display will show "SET" momentarily and revert back to A9.