Canon C70 - Manual (Page 356)

14-12 Summary of Settings Chapter 14
(Default settings are shown in bold type.)
* Even if you have set INCOMING RING to ON, the MultiPASS C70 will only ring if you have connected the handset, a
telephone, or an extension phone to your unit.
** New Zealand: 1 to 5.
ECM RX
RX MODE
INCOMING RING
MAN/AUTO SWITCH
REMOTE RX
MEMORY RX
COLOR RX
Enable/disable Error Correction Mode (ECM) during
reception.
Select the receive mode. Refer to Chapter 8, Receiving
Faxes, for details on setting the receive mode.
If you select FAX/TEL AUTO SW, you can select sub-settings.
For details on these sub-settings, refer to page 8-10.
When the MultiPASS C70 is set to FAX ONLY MODE,
enable/disable ringing when the MultiPASS C70 receives a
call.*
Select the number of incoming rings before the MultiPASS
C70 answers.
When the MultiPASS C70 is in MANUAL MODE, determine
if the MultiPASS C70 switches to fax receive mode after it
rings for a specified time.
If you select ON, select the length of time the MultiPASS
C70 rings before switching to fax receive mode.
Enable/disable remote receiving.
If you select ON, select the remote receiving ID.
Enable/disable memory receiving of a document.
Enable/disable colour fax reception.
ON/OFF
FAX ONLY MODE/
FAX/TEL AUTO SW/
NET SWITCH
ON/OFF
2 TIMES
(1 to 99)**
ON/OFF
15 SEC
(1 to 99)
ON/OFF
25 (00 to 99)
ON/OFF
ON/OFF
Name Description Settings
RX Settings Menu