Lec U50262W - Manual (Page 7)

EN - 5 -
Installation and Switching On The Appliance
• This appliance is connecting to 220-240V and 50 Hz.
• You can offer help from the service to install and switching on the appliance.
• Before making the connection to the power supply,ensure that the voltage on the
name plate corresponds to the voltage of electrical system in your home.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we suggest you to call an authorised
electrician for assistance.
• The plug should be accessible after the appliance is positioned.
• Manufacturer is not responsible for failure to complete the
ground connection as described in this booklet.
• Do not place the appliance in direct sunlight.
• Do not use in open air and shall not be exposed to the rain.
• Place the appliance far from heat sources and in a well-ventilated
position. The freezer should be at least 50 cm from radiators,
gas or coal stoves and 5 cm far from electrical stoves.
• Keep the top free for at least 15 cm.
• Do not place heavy and lots of things on the appliance.
• If the appliance is installed next to another freezer, observe a
minimum distance of 2 cm to prevent condensation.
• Fit the plastic wall spacers to the condenser at the back of the
refrigerator in order to prevent leaning to the wall for good
performance.
• The appliance must be stand firmly and level on the floor Use
the two front levelling-feet to compensate for an even floor.
• The outside of the appliance and the accessories inside should
be cleaned with a solution of water and liquid soap; the inside
of the appliance with sodium bicarbonate dissolved in lukewarm
water. After drying replace all the accessories.
Before Switching On
• Wait 3 hours before plugging the appliance in to the main power
to ensure proper performance.
• There can be an odour when you first switch on the appliance.
It will disappear after the appliance starts to cool.