Lec DF72 - Manual (Page 3)

consider the location
down
up
Your drinks cooler should not be installed on a
carpet,this may prevent proper air circulation
Do not locate your drinks cooler near a heat
source,e.g. cooker,boiler or radiator. Avoid
placing in direct sunlight.
When installing it is important to keep a minimum
clearance of 25mm(1 inch) all around the cabinet
and 6 inches at the back, to allow for ventilation.
unpack your drinks cooler
Remove all extemal and internal packing
clean your drinks cooler
We recommend that you clean your drinks cooler
before use, refer to the section ‘Cleaning your
drinks cooler’
ensure your drinks cooler is level
Adjust the rotating feet at the front. A very slight
backward lean will ensure that the door closes;
better.
leave your drinks cooler for 2hours
Before switching on leave your drinks cooler
upright for 2hours to allow the coolant fluid time to
settle.
This appliance is intended to be used in
households but is not intended to be
used in applications such as;
– Staff kitchen areas in shops, offices
and other working environments;
– Farm houses and by clients in hotels,
motels and other residential type
environments;
– Bed and breakfast type environments;
Reversing the Door Swing
Tools required: Phillips style screwdriver
/ Flat bladed screwdriver
/ Hexagonal spanner
• Adjust the two levelling feet to their
highest position.
•
All parts removed must be saved to do
the reinstallation of the door.
• We recommend that 2 people handle
the unit during assembly.
If you want to have the door swing
reversed,we recommend that you
contact a qualified technician.you
should only try to reverse the door
yourself if you believe that you are
qualified to do so.
Ensure the unit is unplugged and empty.
•
•
•
• To take the door off it is necessary to
tilt the unit backwards.you should rest
the unit on something solid so that it
will not slip during the door reversing
process.
Do not lay the unit flat as this may
damage the coolant systen.