Lec BC9097ST - Manual (Page 3)

RADIO INTERFERENCE: This
appliance complies with current
British and European Standards
and CE Directives.
STARTING
When unpacking and cleaning are
complete plug the mains lead of
your appliance into a suitable
earthed socket and switch on. It
is essential when using the
appliance for the first time that
you run the appliance for 24
hours before loading to make
sure it's working properly.
COLD CONTROL
The temperature of your
appliance is controlled by the
electronic control (thermostat).
The internal temperature of your
appliance is affected by location,
room temperature, and frequency
of opening the door. The factory
settings of the electronic control
(thermostat) are set to allow for
these conditions. This appliance
is designed to operate in ambient
temperatures between 16°C and
32°C. Operating outside of these
temperature parameters may
cause the appliance to perform
out of specification.
Adjusting the factory settings of
the Electronic Control is not
recommended. However, should
you wish to do so, details relating
to the operation of the Electronic
Control are contained in the
instructions supplied with this
user manual.
ELECTRONIC CONTROL
Front Panel Operation
1. Set temperature
 Press SET button, the set
temperature is displayed.
 Press “▲” or “▼’ button to
modify and store the
displayed value, Press SET
button to exist the
adjustment and display
the cold room
temperature.
 If no more buttons is
pressed within 10
seconds, the cold room
temperature is displayed.
2. Refrigerant LED: During
refrigeration, the LED is on;
when the cold room temp. is
constant, the LED is off;
During the delay start, the
LED flashes.
Note: The temperature controller
cannot be installed in the area
with water drops.
SHELVES
The Bottle Cooler is fitted with
adjustable shelves that can be
moved to suit your storage
needs. The support clips are
removed by pressing them
together and tilting them
upwards. On two door models,
when replacing clip ensure that
the clips with shelf stops are
positioned on the centre rails in
the cabinet, also ensure that all
clips are level before replacing
shelves.
DOORS
The door is opened by means of
a handle screwed onto the front
of the door or (on sliding door
models) a vertical handle on each
glass door. These doors are fitted
with a self closing mechanism for
your convenience. Should for any
reason, the self closing
mechanism fail, to close the door
apply a gentle pressure until the
magnetic door gasket seals
against the cabinet face.
Do not "slam close". Check
periodically to see that there are
no gaps between the gasket and
the cabinet face as this will cause
the cabinet to operate less
efficiently.
4 3