Vermont Casting Louvre Kit - Black DV4136LK - Manual

Louvre Kit - Black
Installation Instructions
Models: DV4136LK
The DV4136LK louvre kit is designed for use on
fireplace model DVB4136 (Item number GF__R6J2)
DVA4136 (Item number GFYN5J0).
Check Carton Contents
Compare shipping carton contents in Figure 1 with
actual parts received for the model trim kit purchased. If
any parts are missing or damaged, contact your dealer
before starting installation.
Contents
Installation Instructions
Hood
Bottom Louvre Assembly
Top Louvre Assembly
Bolt Bag: 5 screws, 2 pivot brackets, 2 clevis pins, 2
clips
Installation Instructions
1. Install the hood to the fireplace with three (3) screws
provided. Align the slots on the hood with the holes
in the top opening of the fireplace and secure with
screws. (Fig. 2)
20014177 6/08 Rev. 1
KT1022
install hood
6/08 djt
Outer Top
Front
Cold Air Box
(3) #8 x 1/2 Sheet Metal Screws
Hood
KT1022
Fig. 2 Install hood.
2. Remove the top lou-
vre assembly from
carton and install
in the top opening
of the fireplace just
below the newly
installed hood. The
hook of the louvre
fits into the brackets
as shown in Figure
3.
3. Install the two (2)
pivot brackets to the bottom of the fireplace and
secure with screws provided. (Fig. 4)
1
2
FP1854
Install louvre
6/08
Louvre
Glass Panel
FP1854
Fig. 3 Install louvre.
������
��������������
����
Basepan Front
Tab
FP1855
Fig. 4 Place pivot brackets into basepan slot.
4. Install bottom louvre to pivot brackets using the
clevis pins provided. Slide the clip pins through the
holes in the clevis pins. (Fig. 5)
Installation complete.
������
���������������������
����
������
����������������
����
Install bottom louvre
into brackets, se-
cure with clevis pin
Install clip pins through
clevis pin
Fig. 5 Install bottom louvre.
KT1024
CAR229
Fig. 1 Carton contents.
CAR229
louvre kit
carton contents
6/08
Hood
Bottom
Louvre
Top Louvre
Screws
Pivot Brackets
Clevis Pins
Clip Pin