Leica Geosystems Leica mojo3D - User Manual User Manual
Page 356
356
Leica mojo3D, mojo3D Enhancements
72. Depending on the steer kit selected, the Enable Stationary Engage screen may
appear. Configure its fields accordingly and tap
to continue. The Steering
Adjustment or the NMEA Configuration screen appears.
73. Depending on the steer kit selected, the Steering Adjustment screen may appear.
Follow the instructions on the screen to adjust the steering. Tap
to continue
and the NMEA Configuration screen appears.
74. If NMEA output is not required tap
to complete the initial setup.
If NMEA output is required, follow the detailed information in "11 NMEA Output".
75. The mojoXact now needs to restart, so tap the Restart Now button and tap
to continue.
The mojo3D will display an error message on completion of connection if
the mojoXact/mojoXact Plus has not restarted completely.
To finalise the mojo3D to mojoXact connection, carry out the following steps:
76. Test the steering function, according to "Testing the auto-steer function, step-
by-step", see "5.4 Testing Auto-Steer".
77. Check the tuning, according to "5.2.1 Tuning Procedure".