Magliner COOLIFT - Manual (Page 10)

1-800-MAGLINE (624-5463) Page 10 www.magliner.com
CooLift
®
General Operation of the Magliner CooLift
A) Storage and Limited Use of Holding Brake
1) Engage the holding brake whenever leaving the CooLift unattended.
2) Pallets on the Magliner CooLift should always be in the down position when not moving.
3) Keep hands, feet and all items clear of the moving parts of the CooLift.
4) Never place hands or feet under a loaded elevated pallet.
5) The holding brake is intended to be used for limited periods of time only.
6) Store the CooLift on a hard level surface.
CooLift with product strapped to deck
Front Underside View
B) Loading a pallet on the Magliner CooLift
1) Make sure CooLift deck is in down position.
2) Push the CooLift under the pallet until fully inserted and the back of the pallet is touching
the back of the cart or the bulk head if one is installed.
3) Press and hold the up switch until the lift deck is fully raised (this is noticeable by the sound
change of the running hydraulic pump and the stop of upward motion of the pallet).
4) Engage the holding brake by depressing the brake lever back toward the horizontal handle
with one hand and flipping the holding brake latch into one of the provided notches to hold
it in place.
Note: Make sure the deck is in the up position prior to fastening the containment strap.
5) Fasten the containment strap to secure the load by: a) firmly grasping the end of the
strap; b) pulling it out from the roll directly over the center of the load taking care not to twist
the strap; c) extending strap far enough to snap into position; and d) hooking strap to the
containment lock located at the lower front end of the cart (see Front Underside View).
6) The maximum stacking height for all models (CTA43, CTA48 and CTA53) models is 50”.
However, never stack a load that is higher than your line of vision.