Troubleshooting guide, Common problems, Listening to the radio – Panasonic SC-DK10 User Manual
Page 56
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do
not soive the probiem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail [email protected], or web
site ().
In Canada, contact Panasonic Canada Inc. Customer Care Centre at 1-800-561-5505, or web site ), or an authorized
Servicentre nearest you.
Reference pages are shown as black circled numbers Q.
Common Problems
No sound.
Turn the volume up.
The speaker cables may be shorted. Turn the unit off, check and correct the connections and turn
the unit on.
@
Sound is unfixed, reversed or
comes from one speaker only.
Check the speaker connections. O
Humming heard during play.
An AC power supply cord or fluorescent light is near the cables. Keep other appliances and cords
away from this unit’s cables.
if possible in your area, turn the AC power supply cord’s plug or connector over to reverse the plug’s
polarity.
“ERROR” is displayed.
Incorrect operation performed. Read the instructions and try again.
“—:—” appears on the display.
You plugged the power supply cord in for the first time or there was a power failure recently.
Set the time. ®
“P61” is displayed.
Check and correct the speaker cords connection.
If this does not fix the problem, there is a power supply problem. Consult the dealer.
The display starts up even after
the unit is turned off.
The demonstration feature (DEMO) is on. Turn it off if it is not required. ®
“DTS NO AUDIO” is displayed.
This unit is unable to decode DTS signals.
“DTS CD” is displayed.
This unit is unable to decode DTS signals.
“DVD U11 ” is displayed.
The disc is dirty. Wipe it with a soft cloth.
“DVD H is displayed,
will be numbers.)
A problem has occurred. Turn the unit off and unplug the AC power supply cord. Wait a moment and
then plug the cord in and turn on the unit again. If the unit is still not working correctly, consult your
dealer.
V)
8
C
S
0:
Listening to the radio
Noise is heard.
The stereo indicator flickers or
doesn’t light.
Sound is distorted.
Use an outdoor antenna. ®
A beat sound is heard.
Turn the TV off or separate it from the unit.
A low hum is heard during AM
broadcasts.
Separate the antenna from other cables and cords.
When there is a television set nearby
The picture on the TV disappears
or stripes appear on the screen.
The location and orientation of thè antenna are incorrect. If you are using an indoor antenna, change
to an outdoor antenna.
The TV antenna wire is too close to the unit. Separate thè antenna wire of thè TV set from the unit.
Listening to tapes
Poor quality sound.
Clean the heads. ®
Recording is not possible.
If the erasure prevention tabs have been removed, cover the holes with adhesive tape. ®
nOT5e24