Panasonic MC-V5746 - Manual (Page 20)

BEFORE REQUESTING SERVICE
A
WARNING
Electrical Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Faiiure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner will
not run. 1. Unplugged at wall outlet. 1. Plug in firmly. Push ON-OFF
switch to ON.
2. ON-OFF switch not turned on. 2. Push ON-OFF switch to ON.
3. Tripped circuit breaker/blown
fuse at household service panel.
3. Reset circuit breaker or replace
fuse.
Poor job of dirt 1. Full or clogged dust bag. 1. Change dust bag.
pickup.
2. Broken belt. 2. Replace belt.
3. Carpet-bare floor setting incorrect. 3. Set in the correct position.
4. Clogged hose or nozzle. 4. Clean hose or nozzle area.
5. Hose not inserted fully. 5. Insert hose.
6. Worn agitator. 6. Replace agitator.
7. Hole in hose. 7. Replace hose.
8. Dust cover improperly installed. 8. Properly install dust cover.
9. Belt not installed on motor shaft. 9. Install belt on motor shaft.
Bare floor option
will not work. 1. Belt improperly installed with bare
floor selector in wrong position.
1. Properly install belt.
Dust escapes 1. Bag improperly Installed. 1. Properly install bag.
the paper bag.
2. Bag torn. 2. Replace bag.
Light will 1. Burned out light bulb. 1. Replace light bulb.
not work.
-
20
-